Once you've plugged the USB-C cable into your CHOMPI and have everything charging up...the real fun can begin!

Flip ON the power switch & wait for the RAINBOW... now you're ready to CHOMP!

Here are a few helpful hints to get you started making sounds! Also, feel free to check out the QuickStart Guide included with your instrument for a basic rundown of CHOMPI's core functions.

Powering On CHOMPI: 

1: To turn on the device, flip the power switch (located on the left side of the rear panel) towards the Lightning Bolt icon

2: Then wait a couple seconds for CHOMPI to fully boot up. Once the "Rainbow" LED animation  is complete, you're ready to CHOMP!

Audio Outputs:

To hear the sounds on your CHOMPI, connect to:

Headphones

If you are planning to use CHOMPI by itself, we recommend plugging in a set of headphones to the "Headphone" jack on the right side of the unit.

This output will contain the master audio signal that is created by CHOMPI's engines, as well as the input monitor signal when you flip the mode switch up to sample new sounds.

External Speaker

If you are using CHOMPI with an external speaker (and/or mixer), we recommend using a 3.5mm stereo aux cable plugged into the "Master Output" jack. This jack is located on the rear/right side of the device (next to the micro SD card slot).

This output contains only the master signal (not the input monitor) so that feedback can be avoided when using the microphone for sampling. 

Quickstart Guide

In addition to the printed material that comes in the box, there's also a handy, simplified version of the Quickstart Guide on the bottom of every CHOMPI :)

QUICK TIP: CHOMPI MODE

As you're getting to know CHOMPI's workflow, one of the most important things to keep in mind is that the device will always boot-up in its default state (AKA: CHOMPI Mode). So if you get stuck, lost or can't seem to figure out what you just did... simply power cycle the instrument to "wipe the sketch clean" and return back to the safe and cozy CHOMPI Mode

Step 04: Other Resources